For monitoring of 120V Smoke Detectors for Alarm or Tampering.

Features

• Miniaturized Unit, Easy to Install and Conceal
• No New Wiring, uses the existing Electrical Power Wiring for Signal Transmission
• Provides Transmitter Identification via Code Selection (DIP Switch)
• Works with all Cepco Receivers, Monitors, and Display Panels

The miniaturized feature allow these units to be installed in electrical outlet boxes with the Detector.

Some examples of system applications are listed below.

• Report of Smoke or Fire
• Report detector tampering

The Model TX-SAM, Smoke Alarm Module, is a low cost miniaturized Powerline Carrier transmitter that is designed to monitor 120 volt Smoke Detectors, and transmit this information, along with it's location code, over the existing AC power wiring to the Receivers or Display Panels. Each unit contains a DIP switch for coding. Click on Coding

The Smoke Alarm Module sends its signal if it is triggered by the presents of smoke fire, or if it is disconnected.

The signals from these transmitters can be monitored at remote locations, using a variety of plug-in receiver modules and/or Display Panels.

These units are designed for hard wire applications. They are solidly encased in a rock hard epoxy compound, measure 2.2 inches, by 1.2 inches, by 1/2 inch, and weigh less than 2 oz. They come with 2-sided tape on the bottom for quick and easy installation and can be concealed in such places as electrical outlet boxes, smoke detectors, OEM equipment, or anywhere 120V AC is available.

For Application information click on   Application Notes
For Price information click on   Pricing
For Ordering information click on   Ordering

Cepco Products 9540 Owensmouth Ave Chatsworth, CA 91311, USA
Telephone (818) 998-8569 Fax (818) 998-8560

Copyright Cepco Products, All rights reserved.
Questions?   Comments?   Suggestions?   Send e-mail to: web@cepcoproducts.com