Features

• Separate ON and OFF Pushbutton Control
• Highly Styled for Desk or Table Top use
• Plug-in Unit, no Installation Required
• Red (LED) Signal Indicator
• May be Mounted in Concealed Location
• No New Wiring, uses the existing Electrical Power Wiring for Signal Transmission
• Provides Transmitter Identification via Code Selection (DIP Switch)
• Works with all CEPCO Receivers, Monitors, and Display Panels

The Plug-In feature allows this unit to be easily installed at both permanent and temporary locations. It plugs directly into any 120V AC outlet.

Some examples of system applications are listed below.

• Emergency call button in psychiatric out patient institutions
• Emergency call button in schools, colleges, and universities
• Emergency call button in municipal, county, state, and federal offices that deal directly with the public, to signal duress situations
• Panic or emergency lighting control
• Access control of doors
• Remote control of gates on residential property
• Nurses call button for sick room
• Buddy system arrangement between neighboring shops and small business for hold-up alert
• Buddy system arrangement between neighboring homes, apartments, condos, for panic or emergency paging

The Model TX-PBT, Pushbutton Transmitter is a low cost pushbutton Powerline Carrier Transmitter that can be used as a panic or emergency paging device, or in other remote signaling applications. They can also be used for the remote control of Gates, Doors, Fans, Blowers, Pumps, etc. The information is transmitted using the existing AC power wiring to the Receivers or Display Panels that identifies the location of the Transmitter. Each unit contains a DIP switch for coding. Click on Coding

The signal from these transmitters can be monitored at remote locations, using any number of a variety of plug-in Receiver Modules and/or Display Panels.

These units are attractively styled for desks or tabletop use. They are ivory in color, with separate ON and OFF pushbuttons (black) and a red signal indicator light that flashes when the unit is transmitting. They have a power cord that plugs directly into the 120V AC power outlet.

The Transmitters comes with rubber feet for desk top mounting, or two sided tape for concealing underneath the desk (your choice).

Only a momentary touch of the ON pushbutton is required for activation. Once activated, they will continue to transmit until deactivated by a momentary touch of the OFF pushbutton.

For Application information click on   Application Notes
For Price information click on   Pricing
For Ordering information click on   Ordering

Cepco Products 9540 Owensmouth Ave Chatsworth, CA 91311, USA
Telephone (818) 998-8569 Fax (818) 998-8560

Copyright © Cepco Products, All rights reserved.
Questions?   Comments?   Suggestions?   Send e-mail to: web@cepcoproducts.com