Features:

• Wall Mounted, Plug-in or Hard Wire Installation
• Reports and Identifies up to 64 ALARM locations
• Displays all ALARM locations simultaneously
• Buzzer sounds (90db, pulsed) during ALARM
• Output RELAY (Form C, NO/C/NC) switch during ALARM
• Manual RESET pushbutton
• Works with all CEPCO Transmitters

The Wall Mounted Monitor Panels are available in the following sizes:

Model RX-MTW32
(32 zones)

Model RX-MTW48
(48 zones)

Model RX-MTW64
(64 zones)

The Model RX-MTW, Wall Mounted Monitor Panel, plugs into, or may be hard wired to the 120 V AC power; no additional wiring is needed. The Alarm signals are received over the AC power wiring from CEPCO Transmitters. The Wall Mounted Monitor Panel work with all CEPCO Transmitters.

When an Alarm signal is received, the Alarm Indicator light, that corresponds to the Transmitter location code, comes ON (Red LED), the Output Relay switches (Form C Relay Contacts), the Buzzer sounds with a pulsed output.

This Alarm condition is maintained until the unit is reset with the Reset Pushbutton. If additional Alarm signals are received during this time, the Indicator light that corresponds to that location code is also turned ON.

The Schematic Diagram of the of the Model RX-MTW is shown below.

You can use the Wall Mounted Monitor Panel in as many locations as you like.

Other Monitor and Display Panels available from Cepco are:
Alarm Display Panel, Model RX-ADP ; and the
Desk Mounted Monitor Panel, Model RX-MTS .

For Application information click on   Application Notes
For Price information click on   Pricing
For Ordering information click on   Ordering

Cepco Products 9540 Owensmouth Ave Chatsworth, CA 91311, USA
Telephone (818) 998-8569 Fax (818) 998-8560

Copyright © Cepco Products, All rights reserved.
Questions?   Comments?   Suggestions?   Send e-mail to: web@cepcoproducts.com