Model RX-MTS8
(monitors 8 devices or locations)  

Model RX-MTS16
(monitors 16 devices or locations)  

Model RX-MTS32
(monitors 32 devices or locations)  

Features:

• Plug-in Installation, no wiring
• Reports and Identifies up to 16 ALARM locations
• Displays all ALARM locations simultaneously
• Buzzer sounds (90db, pulsed) during ALARM
• Output RELAY (Form C, NO/C/NC) switch during ALARM
• Manual RESET pushbutton
• Works with all Cepco Transmitters

The Model RX-MTS, Desk Mounted Monitor Panel, plugs into the 120 V AC power outlet; no additional wiring is needed. The ALARM signals are received over the AC power wiring from Cepco Transmitters. The Desk Mounted Monitor Panel work with all Cepco Transmitters.

When an ALARM signal is received, the Alarm Indicator light, that corresponds to the Transmitter location code, comes ON (Red LED), the Output Relay switches (Form C Relay Contacts), the Buzzer sounds with a pulsed output.

This ALARM condition is maintained until the unit is reset with the Reset Pushbutton. If additional ALARM signals are received during this time, the Indicator light that corresponds to that location or zone code is also turned ON.

The Schematic Diagram of the of the Model RX-MTS is shown below.

You can use the Desk Mounted Monitor Panel in as many locations as you like.

Other Monitor and Display Panels available from Cepco are:
Alarm Display Panel, Model RX-ADP ; and the
Wall Mounted Monitor Panel, Model RX-MTW .

For Application information click on   Application Notes
For Price information click on   Pricing
For Ordering information click on   Ordering

Cepco Products 9540 Owensmouth Ave Chatsworth, CA 91311, USA
Telephone (818) 998-8569 Fax (818) 998-8560

Copyright © Cepco Products, All rights reserved.
Questions?   Comments?   Suggestions?   Send e-mail to: web@cepcoproducts.com