Features:

• Plug-In Unit; No Installation Required
• No New Wiring, uses the existing Electrical Power Wiring for Signal Transmission
• Provides Transmitter Identification via Code Selection (DIP Switch)
• Three (3) Input Trigger Options
• Works with all CEPCO Receivers, Monitors, and Display Panels

The Plug-In feature allows this unit to be easily installed at both permanent and temporary locations.

Some examples of system applications are listed below.

• Link between detached buildings
• Monitoring and Reporting of Emergencies
• Security monitoring
• Stake-out and Surveillance monitoring
• Buddy system hook-up for neighboring houses
• Unauthorized entry monitoring
• Hazard Detector monitoring

The Model TX-BUG3, Plug-in Transmitter, is a low cost, plug-in Powerline Carrier Transmitter that can be used to monitor detectors or other devices, and transmit this information over the existing AC power wiring to the Receivers or Display Panels that identifies the location of the Transmitter.

The signal from these transmitters can be monitored at remote locations, using any number of a variety of plug-in receiver modules and/or display panels. Each unit contains a DIP switch for coding. Click on Coding

These units plug directly into the 120V AC power outlets and have two terminals for input trigger connections that are isolated from the AC power input.

These units are contained in a 2 inches x 3 inches x 2 inches package molded of a tough, fire retardant thermoplastic. It has a 2-pole plug that plugs into one socket of a standard duplex wall socket, leaving the other socket clear for other uses. An integral hold down tab is included for use in securing the unit in place with the wall socket cover mounting screw.

The Schematic Diagram of the Model TX-BUG3 is shown below.

The Model TX-BUG3 is available in three trigger options. The Model TX-BUG3(NO), normally open which triggers when the input terminal are shorted together. The Model TX-BUG3(NC), normally closed, which triggers when the input is opened. And the Model TX-BUG3(DC), which triggers when a voltage is applied (AC or DC, 6 to 24V).

For Application information click on   Application Notes
For Price information click on   Pricing
For Ordering information click on   Ordering

Cepco Products 9540 Owensmouth Ave Chatsworth, CA 91311, USA
Telephone (818) 998-8569 Fax (818) 998-8560

Copyright © Cepco Products, All rights reserved.
Questions?   Comments?   Suggestions?   Send e-mail to: web@cepcoproducts.com