Features

• Miniaturized Unit, Easy to Install and Conceal
• No New Wiring, uses the existing Electrical Power Wiring for Signal Transmission
• Provides Transmitter Identification via Code Selection (DIP Switch)
• Three (3) Input Trigger Options
• Works with all Cepco Products Receivers, Monitors, and Display Panels

The miniaturized feature allow these units to be installed in electrical outlet boxes with the Detector.

Some examples of system applications are listed below.

• Smoke Detector monitoring
• Monitoring and Reporting of Emergencies
• Security monitoring
• Stake-out and Surveillance monitoring
• Buddy system hook-up for neighboring houses
• Unauthorized entry monitoring
• Hazard Detector monitoring

The Model TX-BUG2, Miniature Transmitter, is a low cost miniaturized Powerline Carrier Transmitter that can be used to monitor Smoke Detectors or other devices, and transmit this information, along with it's location code, over the existing AC power wiring to the Receivers or Display Panels. Each unit contains a DIP switch for coding. Click on Coding

The signals from these transmitters can be monitored at remote locations, using a variety of plug-in receiver modules and/or Display Panels.

These units are designed for hard wire applications. They are solidly encased in a rock hard epoxy compound, measure 2.2 inches, by 1.2 inches, by 1/2 inch, and weigh less than 2 oz. They come with 2-sided tape on the bottom for quick and easy installation and can be concealed in such places as electrical outlet boxes, smoke detectors, OEM equipment, or anywhere 120V AC is available.

Four (4), eight-inch pigtail leads are provided. Two or for direct connection to the 120V power (Hot and Neutral), and two are for the input trigger connection (AC power Neutral and the trigger return are common).

The Schematic Diagram of the Model TX-BUG2 is shown below.

The Model TX-BUG2 is available in three trigger options. The Model TX-BUG2(NO), normally open which triggers when the input terminal are shorted together. The Model TX-BUG2(NC), normally closed, which triggers when the input is opened. And the Model TX-BUG2(DC), which triggers when a DC voltage (6 to 24V) is applied.

For Application information click on   Application Notes
For Price information click on   Pricing
For Ordering information click on   Ordering

Cepco Products 9540 Owensmouth Ave Chatsworth, CA 91311, USA
Telephone (818) 998-8569 Fax (818) 998-8560

Copyright Cepco Products, All rights reserved.
Questions?   Comments?   Suggestions?   Send e-mail to: web@cepcoproducts.com