Signal Booster Module
Model TR-BST(HW)
(Hard Wire Installation)

  Features:

• Restores Cepco Products signals to maximum amplitude
• Miniaturized Unit, easy to install
• For use in high current load situation
• Single Phase or 3-Phase Installations

The Model TR-BST, Signal Booster Module, is for use in installations where high current loads over long distances may reduce the Cepco Products  Powerline Carrier Signals to below acceptable levels. This Unit is available in models for plug-in or hard wire installations.

The Model TR-BST(PN), for plug-in installation, can be plugged in at any outlet. It restores the signal to its original amplitude.

The Model TR-BST(HW), for hard wire installations, is connected across the 120 V AC power wiring at Distribution Panel or Outlet Box, and restores the signal to its original amplitude. This Unit measures 2.75 inches, by 1.75 inches, by 0.75 inches, and is encased in a rock hard epoxy compound, and comes with two-sided tape on the back for easy installation.

The Installation Diagrams are shown below.

For Application information click on   Application Notes
For Price information click on   Pricing
For Ordering information click on   Ordering

Cepco Products 9540 Owensmouth Ave Chatsworth, CA 91311, USA
Telephone (818) 998-8569 Fax (818) 998-8560

Copyright Cepco Products, All rights reserved.
Questions?   Comments?   Suggestions?   Send e-mail to: web@cepcoproducts.com